Racor PHL-1R Installationsanleitung PDF herunterladen (Seite 4)

48" APART

Assemble and

install the two

arm supports

Locate ceiling joists for each Arm

support. Arm supports need to be

secured directly to and along ceiling

joists 48” apart.

If installing not along the ceiling joist,

install a 2x4 board that will span 4 of

the joists using lag screws at least

3/8” x 5” long. Pre-drill holes.

6

ceiling joist

stud finder

(not included)

Attach Arm supports to

the ceiling joist, using the

supplied lag screws .

Pre-drill with 1/8 inch pilot

holes into the ceiling joists. Do

not over tighten lag screws.

8

N

Fasten the gear drive

to the axle support without

the bushing , using 4 allen

head cap screws , and the

allen wrench provided.

Then fasten two arms to each

Axle support , using long

machine screws. Each arm should

be secured with 2 machine screws

and 2 nuts .

5

E

Q

R

B

C

D

D

The Axle supports

should be facing away from

each other and the two Arm

supports should line up and

be square to each other.

7

C

D

1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare